Event Schedule     Photos and Videos     MMTTPA Rules     Contact Us

Announcements     Links     Main Page     Results Page      Tractor Rules

10,000 Limited Pro-Stock 4.1

1.  Cubic inch limit for the 10000-lb class is 650 cubic inches displacement.

2.  Kill switches, drivers must be able to emergency stop tractor from tractor seat this must be consider primary kill switch. Air shutoff must be spring-loaded closed.

3.  The turbo compressor inlet diameter to be measured at the face of the wheel, a maximum of 4.1 inches. Tips of the wheel must protrude into opening at least a 1/8 of an inch. Housing may use a reducer or slug if welded in place, no setscrews or provisions to remove slug. Tips of wheel must still protrude into opening.

4.  The turbo exhaust outlet diameter to be measured at the face of the wheel, a maximum of 4.7 inches. Tips of the wheel must protrude into opening at least a 1/8 of an inch. Housing may use a reducer or slug if welded in place, no setscrews or provisions to remove slug. Tips of wheel must still protrude into opening.

5.  No functional waste gates. No air entry after the 4.0 opening in compressor or 4.7 opening in exhaust housing. No MAP width enhancement groves or air entry of any kind. No variable geometry turbos.

6.  Waste gated exhaust housing allowed, but must be altered to look like non-waste gated exhaust housing. All passages internal and external, must be plugged.

7.  One Bosch type injector pump, no sigma style pumps.

8.  No nitrous oxide or propane.

9.  Tire size maximum of 24.5x 32.

10.  Tractor must have side shields covering engine compartment that will contain any fluids or engine parts.

11.  Tractor must have steel flywheel, no cast iron allowed.

12.  Tractors will be equipped with a clutch blanket or steel shield no less than ¼” thick and 5-inches wide.

13.  Engine must run on factory designed fuel.

14.  2 springs to pull throttle back to idle; 1 on pump 1 on throttle handle.